Dow-Key Microwave MS-1U18S-4 Betreibershandbuch PDF herunterladen (Seite 54)

Remote Operation

6.6.2 Setting switch x to position n

x = switch [module] address.

n = position to set and must be within the switches parameter.

(Example: SP10T valid positions are 0 thru 10 only).

Examples:

• ROUTE:SWITCHx n

• ROUT:SWITCHx n

• ROUTE:SWITx n

• ROUT:SWITx n

• :SWITCHx n

• :SWITx n

• ROUTE:SWITCHx:VALUE n

• ROUTE:SWITCHx:VAL n

• :SWITx:VAL n

Possible error codes

5, 10, 12, 13

Factory default value

N.a.

Power on behavior

Keeps last value

*RST effect

SP6T switch: will open all positions

Transfer switch: will close position 1

Timing

The timing to execute a command depends on the length of the command (in

case of concatenated commands).

As a rule of thumb electromechanical switches require approximately 30ms to

switch position. It is safe to consider some safety margin and increase this

timing to 40-50 ms when developing the control software.

Multiple switch commands are not executed in a sequential manner but rather

in parallel.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 64 65

Keine Kommentare

Dow-Key Microwave MS-1U18S-4 Betreibershandbuch Seite 54